What is the outside diameter at its largest. Wanting to change my XTR cranks to single ring

Richard M.

Did the job

Replacing some chainring bolts on a chainring. These are good quality bolts and should last when you put your bike through the wringer.

Carly George

Allen Key on Both sides - need I say...

Familiarity:

I've put it through the wringer

the idea of having a chain ring bolt with an allen head on one side and an insane slot on the other is just dumb. These are kind of bonkers expensive, but they are the only chainring bolts I have seen that are not dumb. Pick up a set and throw your chainring bolt wrench out.

Craig L

Keep it flashy!

Familiarity:

I've put it through the wringer

Add some bling to your 1x drivetrain to match that paintjob. Easy to install, Wolftooth Quality, fantastic fit and finish.

Perry Hall

Holds my chain rings on

I'm building a SS 'townie' and needed these to secure my inner chain ring on the crank. Two sided allen key design is a plus as I don't have a chain ring nut wrench.

Mike Newberry

Expensive but high quality

Familiarity:

I've used it several times

I used these when I switched my triple chainring to a 1x setup. $25 is a bit steep for a five pack of bolts, but they are pretty awesome looking, and they're super rugged.

Patrick

Nicely over priced.

These nuts and bolts are nice and have serveral color options to give your bike a good look. However, $25 dollars is outrageous for a 5 pack. Much cheaper options out there.

Stuart S.

Bolt On

Use these either switching over to a 1X drivetrain or to just gussy up your rig. Clean, easy to install, and worked seamlessly with the Wolf Tooth chainring I installed with these bolts.

John McKone

Nice Nutz!

Familiarity:

I've used it several times

These chainring nuts worked to fill the empty holes in my Zed2 crankset on my Look 695. The large chainring has 10 holes, the small ring uses only 5. While the five are enough, I did not like the look of the empty holes. [Normally used for compact rings.] A single depth nut is needed for this. These are well made and look nice.

Eric B.

Bolted

Short thread style.

el scotto

Size Matters

Make sure your bolts are short enough if you're converting from a triple ring to a 1x front, if they're not, then these short bolts will instantly do the trick. As Statenheimer below states, they are a bit pricey for what they are, but hey, they come in a handful of colors! Sure, there are tab spacers out there, but those just look funky. Get these bolts, and you'll be happy.

el scotto

High Quality

Familiarity:

I've used it several times

These are a nice, high quality part to add a bit of bling to our chainring. Color is nice and vibrant (I got green). Using on a SRAM 1x set-up with alloy bash ring, on an aggressive steel hardtail, so lots of chain movement and use of the bash guard on every ride. Bolts had plenty of length, were easy to tighten, and have stayed tight through several rides. Definitely recommended, even though they may be a little pricey.

Statenheimer

Will these bolts be long enough to work with a sram 1x with sram carbon bash ring?

Jeff H.