- Detail Images
Reynolds58/62 Carbon Disc Wheelset - Tubeless
Item # REY004E
What do you think about this product?
October 19, 2020
Are these tubeless only or tubeless ready?... Can you just use regular clinchers?
January 21, 2020
- I've put it through the wringer
Revised Review: After riding on this wheelset, over a year, I found the disc rubbing to be not a manufacturing defect of the rim but an issue with the actual disc brake and the disc break being prone to rubbing/warping. I have since corrected and identified the disc brake rubbing and the wheelset has performed very well. My Set-Up: CERVELO S5, 2019 Disc Brakes Wheelset 58/62 Tubeless Continental 5000 TL, 28mm (Tubeless setup)
March 18, 2020
How wide to those GP5000s measure on these wheels?
September 4, 2020
most likely its the fork thats flexing when out of the saddle sprint causing disc rotor rub on the pads. The wheel hub is a solid piece that has zero flex that attaches to the fork. i have the same wheelset. on my BMC Roadmachine 01 one, i get brake rub when sprinting, when i put it on my Santa Cruz Stigmata, its quiet no matter what I do. I did notice that on my BMC, the gap on one side of the rotor and brake pad is less than a mm. I would try readjusting the caliper and checking the skewer for proper torque to minimize the noise.
February 3, 2021
What were your tires measured at mounted with the 28mm?
April 22, 2019
- I've used it several times
I had been shopping carbon wheels for quite some time, and really wanted something deeper than 40mm but still manageable in a crosswind. I came across these wheels and they were exactly what I was looking for. I really liked the fact that they were deeper in the rear wheel (62mm) but slightly shallower and thinner in the front wheel (58mm) but not so much so as to be noticeably asymmetrical. Reynolds clearly did a lot of research to find the optimal size for front and rear wheels without sacrificing crosswind stability. I liked the fact that they were tubeless ready and had a wider profile so I would be able to use a 28mm tire to soften the ride a little on a very stiff bike. I was a little concerned that by going for value I would be sacrificing quality in the hubs, so far the hubs seem excellent. After installing them I let them spin a little, left the room for a minute or so, came back, and they were still spinning. I did not have any difficulty getting the tires over the rims (a complaint I hear often about some carbon wheels). Took them for a ride recently and love how the deep carbon resonates. Had the chance to test them in the wind, and at 35-40mph speed downhill in a direct crosswind, I barely noticed any instability in the front wheel, and I am a light rider who has felt pushed around by the wind before. I love the fact that they are setup for disc brakes because I did not like the squeal I heard from carbon pads against carbon rims, and need the stopping power for canyon descents and wet conditions. I would definitely recommend these wheels.
June 18, 2020
I own these wheels and they are awesome., Have never had any flex at the brake/hub. I did have the same problem with a set of Mavics on my old BH G7. The issue was not the wheels - it was the fork. The fork flexed - not the wheels.
February 3, 2021
Do you by chance have the tires measured once mounted with the 28mm? Thanks!