Free 2-Day Shipping on Orders Over $50
12 Days of Deals * See Today’s Deal
Stephen L.

Stephen L.

0 Answers

Stephen L.

Stephen L.wrote a question about on June 26, 2018

What are the approx dimensions (e.g. length, handle diameter, etc) of the insertion tool? Specifically, I’m trying to see if I can fit this into the empty space of my EDC 70cc pump (see pic), which affords ~2.25” in length. And yes, I know OneUp offers their own plug/plier add on, but it doesn’t fit the 70cc pump.



Stephen L.

Stephen L.wrote a review of on June 21, 2017

4 5

Familiarity: I've put it through the wringer

...under warranty! The loops on each side of the shoe that hold the Boa laces started wearing out and eventually broke on my X-Project 1.0's after a few months of regular use. Presumably, the tightening/loosening action of the laces sawed through the loops over time. PI was nice enough to replace them with the Pro's under their lifetime warranty policy. Unfortunately, the new Pros seem use loops of the same material and design, so there's a chance they might wear out and break once again. At least PI assured me that they would be covered again under warranty.

On a side note, PI seems to have revised the sizing. Whereas the older 1.0 ran small, these seem to have similar sizing, at least relative to Shimano (who owns PI, but make/design shoes separately) shoes. I had to downsize by 0.5 when I went from the Pros to the 1.0.