Enduro BearingsTorqTite PF 386EVO to 24mm A/C Steel Bearing Bottom Bracket
Item # ENB0008
- 100% Guaranteed Returns
Free Shipping on orders over $50
What do you think about this product?
November 15, 2018
Lasted 4 months
This lasted 4 months, then the insane creaking began. The only solution I found was to replace this BB with a different one. The BB that originally came installed in my bike lasted much longer without any creaking.
March 29, 2016
Best BB386 Solution
- I've put it through the wringer
After banging my head against the wall with creaking BB386 bottom bracket to Shimano conversions; I finally bucked up and went with this option, and it is exactly what you want and need with a BB386 frame and Shimano or Sram GXP cranks. I cannot overstate my satisfaction with this bottom bracket. This is the reason we now have these on our site, as I have been using them with all of my BB386 builds, since I purchased mine in September 2015. It does not install as easily as other thread-fit type bottom brackets, and does require one cup to be pressed fully into the frame, and the other cup to be started with a press. Installation is not easy; but at the same time, this should never require service, so once and you're done! That said, I did just swap mine from one frame to another, and it was relatively easy compared to my expectations. One other important note is that you will need Enduro's Torqtite specific wrench for installation. If you have or are getting a BB386 frame, and have a 24mm spindle crank, this is the absolute best option available today. Bradley Gehrig Customer Account Manager Office: 801–204-4541 firstname.lastname@example.org
October 18, 2017
Does using this bottom bracket in a 386evo bb involve using loctite or grease as part of the install or is it a dry install? thanks Bob