Today Only, Buy Assos Shorts & Get A Free Jersey »
  • Free Shipping on orders over $50*
  • 100% Guaranteed Returns

Out of Stock

Item # USE0001

Don't worry though, we have a lot more Rigid Seatposts in stock than that.

View similar in-stock products

Item # USE0001


A fact of life in the current world of high end road bikes is that many of the coolest bikes come with the most obscure seatpost size requirements. Good luck in trying to find a nice aftermarket 28.0mm seatpost for your Colnago C50 HP, or a 31.0mm post for a Pinarello Prince. Most high-zoot frames give you no latitude in seatpost choice. Your only choice is the stock post -- an especially worrisome issue for folks who require a non-setback seatpost such as a Thomson, but are stuck with a seatpost with tons of setback.

USE comes to the rescue with their seatpost shims. They allow you to use any 27.2mm seatpost (and every desirable seatpost in existence is made in 27.2mm) in a frame that requires a bigger diameter post. Each size shim is machined to a very high tolerance from 6082 T6 Aluminum, while the largest sizes are made from a special filled engineering Thermoplastic (UPVC) to keep the weight down. Please choose the size shim that matches the exact seatpost diameter of your frame. In other words, a "32.4mm" shim will shim your seat tube down from 32.4mm to 27.2mm.

Reviews & Community

What do you think of the

USE Seatpost Shim

? Share a...

Write a review

No file chosen

Rather attach a photo from another website?

Rather attach a photo from your computer?

    Add a:
  • Share a photo
  • Share a video


Only jpg, jpeg, png, gif or bmp files please.

Submit Cancel

Here's what others have to say...

5 5

31.6 -> 27.2

I got this to fit a different seapost in my BMC. The lip that shows right where the seatpost is inserted is not very noticeable unless you are right down looking at it. Weight was light in my opinion for the size. This size was made of a lightweight rubber, not aluminum. I've got a carbon seatpost in there and it isn't slipping around any. I suspect that the rubber material may help a bit with protecting the carbon from small amounts of overtightening if you aren't using a torque wrench, and it may kill off some more vibration, but those ideas are probably just wishful thinking.