Stan's NoTubes Tubeless Rim Strip $22.50
If our image makes it look as if the Stan's No Tubes Tubeless Rim Strip is a tube, rest assured, it isn't. The Stan's Rim Strip has a Presta valve stem built right into it. It has a removable core -- not only good for replacing damaged valves but also for applying sealant.
Stan's No Tubes Tubeless Rim Strips should fit most standard 26in diameter MTB rims that are 21.5 to 25mm wide. They work with Mavic's 223, 221, 317, 517, 519, 717 rims, and 719, Sun's 0 XC, UFO, and Sub4, as well as DT's 4.1, and most other non-Freeride, non-AM, non-DH rims.
What community has to say
Does what it's supposed to
Used these on regular mtb rims to go tubeless. I did used tubeless tires, so may have not needed these, but following the instructions for my wheels on the Stan's website, I was able to inflate tires with a floor pump and likely could of used a hand pump, the seal was that good. I would still use this system over cutting an inner tube and going that route, it doesn't cost that much more.
Stans No Tubes
- Gender: Male
- Familiarity: I've put it through the wringer
These are great! Very easy to install, go to a gas station that has an air compressor as opposed to trying to use your hand pump.
These virtually eliminate flats.