Cane Creek 40 Series Mixed Tapered Headset $74.00
A fork with a tapered steerer adds stiffness to the front end of the bike to improve tracking and steering control through rough terrain. It's a real benefit for long travel trail bikes bridging that gap between cross-country light and all-mountain capable. This Cane Creek 40-Series Mixed Tapered Headset is a great choice to mate your tapered fork to a tapered head tube since it's nearly as high tech as their 110-Series headsets, but it costs a good bit less. Money for more parts? You bet.
Where the 110 headset has cups machined from 7075 T6 aluminum, this 40-Series Headset is crafted from 6061 T6 alloy. The functional difference is one of a few grams, with the higher tech alloy of the 110 headset allowing a lighter overall part. This 40-Series Headset spins on Cane Creek's black oxide bearings. The races and balls start out as 52100 steel and are then given an acid bath to make them more corrosion resistant, while still being porous enough to retain grease. They are angular contact bearings (ACB), which resist both axial and radial loads equally well. The cartridges are sealed with what Cane Creek likes to call a Split Lip Seal, which has two contact seals per side to better keep out contaminants and hold in grease.
To augment the seals on the cartridge bearings, Cane Creek adds face seals to the crown race and top assembly. So what if the bearings aren't stainless -- grease kept in and muddy goop kept out keeps 'em running like new for a long time. In the event that you might wreck the bearings through normal use or abuse, you should know that all the internal parts in this 40-Series Headset are compatible with their top-of-the-line 110-Series Headset. So you could always upgrade to the 110 headset's stainless steel bearings. The Clip-Seal in the upper assembly holds all the parts together, including the compression ring. This makes assembly a cinch, since there are no loose parts to misplace or install backwards.
The Cane Creek 40-Series Mixed Tapered Headset is anodized Black. Cane Creek adds laser etched graphics including their Skink logo. This is a mixed tapered headset that will mate a fork with a 1-1/8" - 1.5" tapered steerer tube to a tapered head tube having a 44mm i.d. top and a 49mm I.D. bottom. The top bearing cover is compatible with Cane Creek Interlok spacers.
What community has to say
I am trying to understand...
I am trying to understand headsets. I am new to this but planning to build a Santa Cruz Highball Carbon with a fox 23 float 29 evolution tapered CDT. Santa Cruz site says they use a Cane Creek 40 Series Mixed Tapered Headset, SHIS name being ZS44/28.6 EC49/40. Is this the right headset or is there other options (in the Cane Creek serie of headset)? I see a lot of headsets with EC49 at the bottom, what the difference with TR49? Will EC49 work too?
Also, the top cover is long on this headset, does that reduce the amount of spacer I can put compare to a short top?
This is the 40 mixed tapered headset that is used on the Santa Cruz Highball. I haven't ever heard of the "TR" variant, most headsets are either and external cup (EC), zero stack (ZS) or integrated. The highball uses a ZS top cup and an external lower cup. Please call me directly at 801-736-6396 x4378 and I'd be happy to help with your build or any other questions you may have.
I did not mean TR was a variant per say. If you look at the picture you have online on this page, the bottom cup shows TR49, but I have seen EC49 written on it in most website. So I don't understand the difference. I have been researching more, and maybe that is an old picture and the new models show EC49 on the bottom cup?